CDL Gateway™ - Siemens PLC Version

NOW C-UL APPROVED FOR CI DII GROUPS A-D HAZARDOUS LOCATIONS! The Siemens version of the Monico CDL Gateway™ provides complete engine and generator data in the form of a Siemens PLC Data Map. It is compatible with the S7 and S5 Series PLC Models. With three ports to choose from you should have the right solution for your application in a single unit. Since the CDL Gateway™ is a pre-configured product, field setup is minimal and programming is not required. The CDL Gateway™ populates Data Blocks in the host PLC with engine data which can then be read by the host. This version not only eliminates the need for the CCM module and the PL1000E, but also eliminates the need to convert from Modbus in the PLC. Using TCP/IP, the CDL Gateway™ pushes all values into the Data Block registers without any setup required in the PLC. Available Ports & Protocols S7/S5 via PPI over RS-485 via RJ-45 Jack. S7/S5 via PPI over RS-232 via RJ-11 Jack. S7/S5 via TCP/IP thru RJ-45 Jack. Features Include User configurable port settings and device addresses. Updates approximately 15-20 parameters per second. Integral 24 VDC power supply with Din-Rail Mounting. Pre-configured register data map.(Custom Mapping Available Upon Request) All values provided in consecutive Data Blocks starting at DB1000:0000 to avoid existing address conflicts. Downloads CDL Gateway™-Siemens Version Datasheet CDL Gateway™ Operation Manual CDL Gateway™ Combined Data Map CDL Gateway™ Quote/Application Request